COBHAM SOLO4 Especificações descarregar pdf (Página 61)

IP Address

This control allows the user to change the IP address of the unit. The

factory default value is 192.168.0.71.

The user should make a note of the unit’s new IP address when

changing it. Failure to do so will result in an inability to use the web

browser interface until the unit’s new IP address is recovered.

Multicast Address

This control allows the user to change the multicast address used by the

unit. The default valu

e is 239.16.33.254.

Port Number

This control allows the user to change the multicast port used by the

unit. The default value is 10000.

TTL

This control allows the user to change the value of the IP TTL (Time to

Live) set by the unit.

SAP Address

This control allows the user to change the value SAP/ SDP multicast

address used by the unit. The default value is 224.2.127.254 and the

port used is 9875. These are standard multicast

values for such

parameters, and it is recommended they are not changed unless

specifically required due to routing restrictions.

SAP / SDP Data

Note – SAP is Session Announcement Protocol and SDP is Session Description Protocol

as defined in RFC2327 and RFC2974

• Service Name – textual information naming the multicast stream as

delivered in the SAP/SDP packets from the unit. Default is “MPEG

Stream”

• Info – further textual information about the multicast stream as delivered

in the SAP/SDP packets from the unit. Default is “NetEng”

• Description - Optional URI (Universal Resource Identifier) pointing to a

web page on the network containing additional informati

on about the

multicast. Default is www.domo.co.uk

• Bitrate - textual information indicating the bitrate in kbits/s of the stream.

Default is usr kbit/s

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 98 99

Sem comentários

COBHAM SOLO4 Especificações Página 61