COBHAM SOLO4 Especificações Página 39

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 99
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 38
39
The amount of attenuation required is shown bellow.
Note the SOL4TXLE-138139 (1.389 to 1.399GHz), SOL4TXLE-240248 (2.4 to 2.483GHz),
SOL2TXLE-138139 (1.389 to 1.399GHz) SOL2TXLE-240248 (2.4 to 2.483GHz)must not
be connected to 5W PA, because these elevated power levels are not permitted in the
license exempt bands.
AMP5W-120140
AMP5W-230250
SOLO2 Transmitter
0dB Attenuation
10dB Attenuation
SOLO4 Transmitter
0dB Attenuation
10dB Attenuation
If customers are concerned about balancing the input power when connecting 5W
amplifiers, then they should contact domo directly.
DC Power
Push the connector on the DC power cable into the socket labelled
12V, taking care to align the connectors. Connect the banana
connectors on the other end of the cable to a suitable DC source.
The 12V DC input has the following characteristics.
Input Voltage Range 12V +/- 1V, reverse voltage protected.
Current Draw 7.5A AMP5W-230250, 2.5A AMP5W-120140
Antennas
domo 5W Amp is supplied without antennas as standard. It is good
practice to ensure that an antenna is always connected before powering
the device. Prolonged operation without an antenna is not
recommended. The antenna should be connected by screwing it to the
N Type output connector with adapters as required, but care should be
taken not to over-tighten.
Note: It Is recommended that where possible antennas should be connected
directly to the 5W Amp. Use of cables will degrade performance.
Vista de página 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 98 99

Comentários a estes Manuais

Sem comentários