COBHAM SOLO4 Especificações descarregar pdf (Página 30)

Control Cable

The control cable is used for connecting the SOLO receiver to a PC

when using the domo PC control application. The PC control

application is described in more detail the Advanced Operation section

of this handbook.

Data Connection

The SOLO receiver features a general purpose DATA port used for

outputting RS232 data transmitted from a SOLO2/4 transmitter.

Installation Notes

The domo SOLO receiver has been designed so that the down-

con

verter units are mounted remotely from the receiver unit, and

connected via the 3 metre TNC cable.

The down-converter units should be connected directly to the receive

antenna, but where this is not possible a short length of low loss RF

cable such RG213C/U should be used. System performance will be

degraded by the introduction of RF losses at this point.

The down converter should be screwed or strapped

to a flat surface or

pole, using the integral mounting holes on the unit. The down converter

is weather proof, and has no special cooling requirements. If the down-

converter is mounted where it is exposed to the weather then the

connector labelled ‘ANT / IN’ should face upwards.

The antenna itself should be separately secured, the TNC connectors

should not be expected to take the strain of the anten

na.

The domo SOLO2/SOLO4 receiver is designed to be mounted in an

equipment rack or shelter and must not be exposed to the elements.

The receiver is splash resistant, but is not waterproof, so it should not be

exposed to moisture for prolonged periods.

The receiver is self-cooling; however it should be mounted in a

ventilated environment. Forced air cooling is not required. Adequate

clearance on either

side the receiver (5cm) should be allowed for

ventilation.

The receiver is supplied with a mounting plate that allows the unit to be

screwed or strapped to a flat surface.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 98 99

Sem comentários

COBHAM SOLO4 Especificações Página 30