COBHAM SAILOR Fleet One Manual de Instalação Página 31
- Página / 132
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Chapter 2: Installation
98-141368-A 23
Pinout
The power connector is a Mixed D-Sub connector 7W2, control pin male/ power pin male. The
below table shows the pinout for the connector and the colours of the corresponding wires.
To connect DC power to the terminal
Do as follows to connect the power cable:
1. Connect the red (+) and black (-) wires of the supplied power cable to the ship’s 24 V DC
supply according to the recommendations in the previous sections.
2. Connect the D-sub connector on the power cable to the DC input connector on the
terminal.
If you need a remote on/off function, you may use one of the following options:
• Connect the Remote on/off wires in the power cable to a remote switch. For further
information, see To connect a remote on/off switch on the next page.
• Connect the ignition pins in the I/O connector to the ignition of your vessel. For further
information, see To connect to the ignition on the next page.
For specifications of the DC input on the terminal, see Power input on page 115 in Technical
specifications.
Pin number Pin function
Colour of wire in
power cable
A1 Vin+ Red (thick)
A2 Vin- Black (thick)
1 Not connected Black (thin)
2 Remote on/off Green
3 Not connected Brown
4 Not connected Red (thin)
5 Remote on/off Orange
A2 5 4 3 A1
2 1
Note
If the supplied power cable is not long enough, see Power cable selection on
page 34.
- SAILOR Fleet One 1
- Disclaimer 2
- Trademark acknowledgements: 2
- Safety summary 1 3
- 98-141368-A iv 4
- Related documents 5
- Typography 5
- Table of contents 6
- Chapter 5 Configuration 7
- Chapter 1 9
- Introduction 9
- Features and interfaces 10
- Main units 11
- Tools for setup and use 12
- Available services 12
- Satellite coverage 13
- Chapter 2 14
- Installation 14
- Obstructions 15
- Radiation hazard 16
- Interference 16
- Radar distance 17
- 98-141368-A 10 18
- Antenna mast design 19
- Antenna mast length 20
- Install the antenna 21
- Important mounting notes 22
- Mount the antenna 23
- Where to place the terminal 24
- Install the terminal 25
- 98-141368-A 18 26
- 98-141368-A 19 27
- 98-141368-A 20 28
- Connect cables 29
- DC power input 30
- 98-141368-A 23 31
- To connect to the ignition 32
- Phone interface 33
- LAN interface 34
- 98-141368-A 27 35
- 12345678 36
- I/O pin functions 37
- 98-141368-A 32 40
- 98-141368-A 33 41
- Power cable selection 42
- Power cable recommendations 43
- 98-141368-A 36 44
- Chapter 3 45
- Get started 45
- Power up the SAILOR Fleet One 46
- Connect a smartphone 47
- 98-141368-A 40 48
- Connect an IP handset 49
- Connect an analogue phone 50
- Connect a computer 50
- Make a call 51
- Connect to the Internet 52
- Chapter 4 53
- Operation 53
- Call log 54
- To make local phone calls 55
- Dialling functions 56
- Data connection 57
- Physical connection options 58
- To access the Internet 58
- The built-in web interface 59
- Overview of the web interface 60
- To navigate the web interface 61
- Dashboard 62
- 98-141368-A 55 63
- 98-141368-A 56 64
- Phone book 65
- To edit the phone book 66
- SMS messages 68
- 98-141368-A 61 69
- To configure message settings 70
- Do you need a SIM PIN? 71
- To enter the SIM PIN 71
- 98-141368-A 64 72
- Wrong PIN 73
- Chapter 5 74
- Configuration 74
- Set up the data connection 75
- Set up the interfaces 76
- 98-141368-A 69 77
- 98-141368-A 70 78
- 98-141368-A 71 79
- 98-141368-A 72 80
- Select a preferred satellite 81
- Log on as administrator 82
- 98-141368-A 75 83
- 98-141368-A 76 84
- Save or load a configuration 85
- Call charges 86
- Log handling 87
- Data limits 87
- Configure the SIM PIN 88
- To change the PIN 89
- Set up user permissions 90
- Restricted dialling 91
- 98-141368-A 84 92
- External data connections 93
- 98-141368-A 86 94
- Track the SAILOR Fleet One 95
- 98-141368-A 88 96
- Antenna RF noise filter 97
- Chapter 6 98
- Update software 99
- 98-141368-A 92 100
- Part numbers 101
- Troubleshooting guide 102
- 98-141368-A 95 103
- Status signalling 104
- Generate a diagnostic report 105
- Event messages 106
- 98-141368-A 99 107
- 98-141368-A 100 108
- 98-141368-A 101 109
- 98-141368-A 102 110
- 98-141368-A 103 111
- 98-141368-A 104 112
- Extended status 113
- Antenna properties 113
- Self test 114
- Reset button 115
- 98-141368-A 108 116
- List of reserved subnets 117
- Appendix A 118
- Technical specifications 118
- Environmental specifications 119
- 98-141368-A 112 120
- Dimensions are in mm 121
- SAILOR Fleet One terminal 122
- 98-141368-A 115 123
- 98-141368-A 116 124
- Weight: 2.2 kg 125
- Glossary 126
- 98-141368-A 119 127
- 98-141368-A 120 128
- 98-141368-A 121 129
- 98-141368-A 122 130
- 98-141368-A 123 131
- 98-141368-A 124 132
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.179 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais