
Chapter 6: Maintenance and troubleshooting
98-141368-A 104
0804B Illegal
combination of
antenna and
terminal
You are not using the right
combination of antenna and
terminal.
Only use the antenna(s)
intended for use with your
terminal.
0804C The selected
satellite is not
visible at
current GPS
position
The terminal is set up to use a
satellite that is not visible at
the current GPS position.
Enter the web interface and
select SETTINGS > Satellite
selection.
Then select Auto to let the
terminal automatically find the
satellite with the best signal, or
select a satellite visible from
your current position.
0804D Antenna firmware
image is missing
in terminal
The software is corrupt Upload new software to the
terminal. Refer to Uploading
software on page 96.
08054 Transmission
aborted due to
extreme
temperature
The system stops all
transmission due to:
• critically high temperature
in the HPA or ACM module
of the antenna, or
• too low temperature in
the ACM module.
None. The antenna must
operate within the allowed
temperature range to work
properly. For information on
ambient temperature limits,
see the installation manual.
08056 USIM rejected The type of USIM card
inserted in the terminal is not
correct for your terminal.
Make sure you have the correct
type of USIM card. E.g. an
USIM card for a land-mobile
system will not work for a
maritime system and vice
versa.
08060 NAT session
table full
There are too many open
connections through NAT -
typically too many users
generating too much web
traffic.
Do not establish new
connections until the load has
been reduced.
ID Event Text Explanation Remedy
Comentários a estes Manuais