COBHAM C406-2 SERIES Especificações descarregar pdf (Página 23)

Artex Aircraft Supplies, Inc. 570-0049 Revision -

Page 23 of 30

9.1.7 Press firmly and evenly over the label to produce maximum adhesion.

9.1.8 Slide the locking ring on the toggle switch.

Figure 8: Toggle Switch Locking Ring

9.1.9 Slide the bat of the toggle switch through the cutout and insert the tongue of the locking ring

inside the smaller hole.

9.1.10 Install the lockwasher and the mounting nut over the thread of the toggle switch.

9.1.11 Secure the nut using a torque screwdriver set to 6 lb-in (.67 Nm).

591-0037 Label Assembly 591-0092 Label Assembly

Figure 9: Hardware installation

9.1.12 Fasten the harness to the aircraft and ensure that it has enough slack to prevent tensile load on

the contacts of the toggle switch.

9.1.13 Plug the D-sub connector leading from the harness on the toggle switch to the 453-0032

interface.

9.1.14 Refer to the Transmitter Test section of the appropriate ELT manual to check the operation of the

complete connection to the ELT.

Locking Ring

Tongue

Bat

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Sem comentários

COBHAM C406-2 SERIES Especificações Página 23